Ohaus RANGER ADVANCED COMPACT COUNTING SCALES Manual en - Manual (Page 16)

Ranger RP
16
Operation
With automatic start Prerequisite
AVErAGE -> AUtO is selected in the menu.
The weighing sample must be heavier than 5 scale divisions.
1. Place the weighing sample on the scale.
The scale starts the dynamic weighing automatically.
During dynamic weighing, horizontal segments appear in the display, and the
dynamic result is then displayed with the symbol
*.
2. Unload the scale to be able to perform a new dynamic weighing operation.
2.7 Weighing-in to a target weight and checkweighing
The compact scales Ranger RP allow the weighing-in of goods to a particular target
weight within defined tolerances. With this function it is possible to check
whether weighing samples are within a defined tolerance range.
The compact scales Ranger RP have a
total of 100 memory locations for frequently
used tare values, average piece weights, target weights and target quantities.
In the factory setting, the memory locations 81 to 90 are reserved for target weights.
The saved target weights are also preserved when the scales are switched off.
2.7.1 Saving target weights
1. Enter the memory location number (factory setting: 81 ... 90) and keep
Mem
pressed until the confirmation tArGEt appears in the display.
2. Enter the target weight in the defined unit, e.g. 1.5 kg, and confirm with Yes.
The display tOLER appears and + flashes.
3. Enter the upper tolerance in the displayed weight unit, e.g. 0.1 kg, and confirm with
Yes
-or-
Press Yes , enter the upper to lerance range in percent and confirm with Yes.
The display tOLEr appears and – flashes.
4. Enter the lower tolerance accordingly.
The scale returns to weighing mode.
Note If a target weight had already been saved under the selected memory location, the
message rEPLACE appears in the display.
• To save the new target weight, press Yes . The old target weight is overwritten.
• To abort the save process, press No. The pre vious memory location assignment
remains valid.