Ohaus RANGER ADVANCED COMPACT COUNTING SCALES Manual en - Manual (Page 39)

Settings in the menu Ranger RP
39
4.4.4 MEMORY – configuring memory
CONFIG Configuring the memory partitions.
40-40-10 Ranger RP have a total of 100 memory localizations that can be assigned
to tare values, average piece weights, target weights and target quantities.
Factory settings:
• 40 memory locations for tare values (01-40)
• 40 memory locations for average piece weights (41-80)
• 10 memory locations with target weights (81-90)
• 10 memory locations with target quantities (91-100)
The first target weight is called up e.g. with memory address No. 81.
Changing the range for the memory locations:
1. Enter the new range and separate each range with a point (e. g. 30.30.20). The
last range is automatically calculated. If an invalid entry is made, NOt.ALLO
is shown in the display.
2. Confirm with Yes.
Since only some of the entered values can be shown in the display, the display can
be moved to the right with the aid of the
No key.
Note
After every new partitioning, always check the memory values and adjust if nec-
essary!
CLEAr.M Clearing all memories.