Ohaus RANGER ADVANCED COMPACT COUNTING SCALES Manual en - Manual (Page 37)

Settings in the menu Ranger RP
37
4.3.10 RESET – resetting scale settings to factory settings
4.4 Application settings (APPLICATION)
4.4.1 COUNT – settings for counting
SUrE? Confirmation inquiry
• Reset the scale settings to factory settings with Yes
• Do not reset scale settings with No
VAr-SPL Adaptation of the reference quantity
ON • The reference quantity can be changed in operating mode
OFF • Counting only with defined reference quantities
Min.reFW Monitoring the minimum reference weight
OFF • No monitoring of the minimum reference weight
97.5, 99.0,
99.5
• Monitoring the minimum reference weight so that a counting accuracy of
97.5 %, 99.0 % or 99.5 % is achieved
rEF.OPt Optimizing the average piece weight
OFF • No reference optimization
AUtO • Automatic reference optimization
A-SMPL Automatic determination of the average piece weight
ON • After taring, the average piece weight is determined with the next weight placed
on the scale and the displayed reference quantity
OFF • No automatic determination of the average piece weight
A.CL-APW Automatic clearing of the average piece weight
ON • When the load is taken off the scale after a counting operation, the average piece
weight is automatically cleared. The next counting operation begins with deter-
mining the average piece weight again.
OFF • The average piece weight must be cleared manually by pressing C
ACCurCY Displaying the counting accuracy
ON • After the average piece weight is determined, the counting accuracy that can be
achieved is shown briefly in the display.
OFF • No counting accuracy display
tOtAl.Ct Counting on two scales
bULK • Display number of pieces for the parts on the bulk scale only
bOth • Display number of pieces for all parts on the bulk and the reference scale