Ohaus RANGER ADVANCED COMPACT COUNTING SCALES Manual en - Manual (Page 14)

Ranger RP
14
Operation
2.4.5 Taring by calling up a saved tare value
Ranger RP have a total of 100 memory locations for frequently used tare values,
average piece weights, target weights and target quantities. In the factory setting,
the memory locations 01 to 40 are reserved for tare values. The saved tare values are
also preserved when the scale is switched off.
Saving tare weights
1. Determine the tare weight in one of the ways described earlier.
2. Enter the memory location number (factory setting: 1 ... 40) and keep
Mem
pressed until the confirmation appears in the display, e.g. tArE.12.
Note If a tare weight had already been saved under the selected memory location, the mes-
sage rEPLACE appears in the display.
• To save the new tare weight, press Yes. The old tare weight is overwritten.
• To abort the save process, press No. The previous memory location assignment
remains valid.
Calling up tare weights
Enter the number of the memory location with the required tare weight (factory set-
ting: 1 ... 40) and press
Mem briefly.
The selected tare value is loaded from the memory and appears briefly in the dis-
play. The scale tares with the selected tare value and then displays the current net
weight.
Clearing saved tare weights
1. Enter the number of the memory location with the tare weight to be cleared (factory
setting: 1 ... 40) and press Mem briefly.
The saved tare value is displayed.
2. Press C within 2 seconds.
CLEArED briefly appears in the display. The saved tare value is cleared.