M&C TechGroup SP2020-H_C_I_BB_F Operator's manual - Manual (Page 8)

8
Gas sampling and gas conditioning technology 2-1.1.6.1-ME
7 TECHNICAL DATA
Mains supply 115V 60Hz 800W
Flange SS316Ti, 3” 150 lbs
Electrical connection terminals; max 4mm², 2x PG13,5 cable gland
Protective type IP54 (EN 60529)*
Ambient temperature thermostat:
-20°C to 60°C
PT100, thermocouple:
-20°C to 80°C
Operating temperature SP2020-H... : 0-180°C
SP2020-H220... : 0-220°C
Ready for operation after 2 hours
Temperature status alarm point

30°C to T
Set
*
Alarm contact rating 250V 3A AC, 0,25A DC
Connection sample outlet 1/4"-NPT i., for max. 10mm tube connectors
Connection backflush tube fitting 3/8” o.d.
Connection calibration gas tube fitting ¼” o.d.
Filter chamber volume 120 ml
Sample pressure 0,4 to 6 bar abs.
Material of sample conducting parts SS316Ti, Viton*
alternative = SS316Ti, PTFE
* = Standard
Differential pressure and T
90
-time at different flow rates:

P and T
90
at flow of 100 200 500 1000 1500 Nl/hr

P with new filter element
S-2K 150 or F-0,1GF150:
0,007 0,011 0,020 0,035 0,04 bar
T
90
-time without sample tube/pre filter: 6,0 3,5 1,0 <0,5 <0,5 sec.
8 APPLICATIONS
The SP2020... gas sample probes are used for continuous extraction of gases from dust loaded,
high-temperature or humid processes.
A host of different variations in sampling technology as well as some built-in accessories offer a wide
range of possible applications for nearly all problems encountered in taking gas samples from proc-
esses with high dust content where an effective backflush is necessary. Sampling from processes up
to a maximum of 1900°C are possible with this probe.