M&C TechGroup SP2020-H_C_I_BB_F Operator's manual - Manual (Page 13)

13
Gas sampling and gas conditioning technology 2-1.1.6.1-ME
12 MOUNTING
M&C SP2020.. probes are designed for stationary use and if properly selected and mounted a long
service life and minimum maintenance are guaranteed.

Remove the probe's protection shield after opening the two clamping devices.

Turn the U-bolt at the front end of the filter receptacle several times to the left until the retain-
ing bolt can also be turned sideways to the left.

Remove the filter receptacle from the probe and check whether the filter element is screwed
on tightly.

Then replace the filter receptacle, place the retaining bolt in its original position and tighten the
U-bolt.

Remove the heat-conducting jaws at the sample gas outlet after loosening the knurled-head
screw.

In order to connect the sample line, screw in a suitably sized threaded connector with a ¼"-
NPT connecting thread using PTFE sealing tape.
N O T E !
Make sure that the connection is leakproof!

Screw either the probe tube or prefilter supplied directly or using an extension tube into the ¾"
inner thread in the flange of the probe with the ¾" flat gasket and tighten.

If the heated probe tube type SP30/35 or the ceramic prefilter type V12 is used, then the
probe is to be screwed to their flange (with welded threaded bolt). First insert the flange seal
between the two flanges.

If the probe connection does not correspond to the standard flange connection , then the op-
tionally supplied adapter flange should be mounted to the probe in the same way.
3 “ 150 lbs
Figure 1 Probe mounting with adapter flange or R2” adapter