M&C TechGroup SP2020-H_C_I_BB_F Operator's manual - Manual (Page 17)

17
Gas sampling and gas conditioning technology 2-1.1.6.1-ME
N O T E !
Attention must be paid to the requirements of IEC 364 (DIN VDE
0100) when setting high-power electrical units with nominal volt-
ages of up to 1000 V, together with the associated standards and
stipulations.
In any case we recommend the use of temperature resistant cable !
A main switch and matching fuse must be provided externally!
The main circuit must be equipped with a fuse corresponding to
the nominal current (over current protection); for electrical details
see technical data.
13.1 STANDARD VERSION WITH INTERNAL CAPILLARY TUBE THERMOSTAT

Remove the lid of the connection box. The electrical connection layout is located in the lid.

Insert the mains cable (min. 3 x 1.5 mm²) through the treaded cable gland and connect to the
appropriate terminals.

Insert the signal cable through the treaded cable connection and connect to the appropriate
terminals.

Screw lid back on.
Figure 5 Electrical connection at the capillary tube thermostat