M&C TechGroup SP2006-H280_DIL Operator's manual - Manual (Page 17)

17
Gas sampling and gas conditioning technology 2-1.1.7.2-ME

Turn the clamp clip B to the left side (direction G);

Pull out the filter housing cover with the toggle handle A.
The photos shall illustrate the above mentioned steps.
Figure 11 Dismounting of the filter housing cover
Now, the filter element is visible.

Check on the filter pressing screw whether the filter element is screwed on tightly.

Push the cover with filter element into the probe again.

Turn the clamp clip B to the right side and bring the ring bolt D into position E by using the handle
C so that the clamp clip locks into place of the ring bolt D and the threaded bolt H. For this pur-
pose, you may push in or pull out a little the filter housing cover by means of the straining screw
A; afterwards, turn the handle C into position F and screw the toggle handle A hand-tight by turn-
ing to the right.
14 INSTALLATION
The M&C dilution probes SP2006-H.. are designed for stationary use. With correct selection of the
sample point and proper installation, they will work for many years with a minimum of maintenance
required.