M&C TechGroup PSS-10_1 Operator's manual - Manual (Page 11)

11
Gas sampling and gas conditioning technology 4-2.1.2-ME
10 RECEIPT OF GOODS AND STORAGE
The portable gas conditioning and sampling system PSS-10/1 is a completely pre-fitted unit.
The sample gas probe, sample gas line, connection cable and instruction manual are located in the
inside part of the case door.

Please take the portable gas conditioning system and possible special accessories carefully out of
the packaging material immediately after arrival, and compare the goods with the items listed on
the delivery note;

Check the goods for any damage caused during delivery and, if necessary, notify your transport
insurance company without delay of any damage discovered.
N O T E !
The PSS must be stored in a weather-protected frost-free area!
11 INSTALLATION INSTRUCTIONS
N O T E !
When in use, the gas conditioning system case should be placed in an area
well away from any heat emitting sources in order to prevent damage
caused by an accumulation of heat. The air vents in the case must be free
at all times.
In order to ensure that the case is safe and stable when being used, it
should be laced on a horizontal surface.
The equipment is to be used in a vertical position only. The perfect
functioning of the separation and drainage procedures will only be
guaranteed if the equipment is used in a vertical position.
When the equipment is being used outside, ample protection against the
effects of direct sunlight and dampness must be provided. In winter, the
equipment must only be used in frost-free areas;
It is recommended that the case be protected using one of the many
models available.
In order to guarantee the operational safety of the gas conditioning system
and the additionally connected analysers, and to avoid false alarms, the
gas conditioning system should not be used at temperatures other than
those specified.
It is of great importance that the analysers which have been additionally
connected be used at temperatures well above the specified gas outlet dew
point of +5°C. This prevents the gas in the connector lines from condensing
completely.
In the event of the unheated sample gas lines being connected to the gas
conditioning system on a slope, it is not necessary to carry out a
preliminary condensate removal