M&C TechGroup SP3200 Operator's manual User Manual
Page 3

2-1.3.9-ME
Gas sampling and gas conditioning technology
3
1
EQUIPMENT STANDARD
The equipment standard of the gas sample probe and the options correspond to the safety requirements of
EC Directive 94/9/EG.
The respective type of protection depends on the variant (see table 4).
Manufacturer: M&C TechGroup GmbH
Rehhecke 79
40885 Ratingen – Germany
Tel.: 02102/935-0
E-Mail:
www.mc-techgroup.com
2
SAFETY INFORMATION
Please observe the following fundamental safety precautions when using the device:
Read these operating instructions carefully before start-up and use of the device! The
information and warnings given in these operating instructions must be heeded.
The declaration of conformity must strictly be observed (see enclosure).
Work on electrical equipment may only be carried out by qualified personnel in ac-
cordance with the regulations actually valid.
When erecting high-voltage power installations with rated voltages up to 1000 V, the
requirements of VDE 0100 and its associated standards and regulations must be ob-
served.
For use of the device in hazardous areas, the relevant national and international
standards and regulations must be observed.
The device must be connected to a mains supply with the same voltage as specified
on the rating plate.
Protection against contact with high electrical voltages:
The device must be safely isolated from the mains supply before it is opened. The
same applies to any connected external control circuits.
Only use the device within the permissible temperature ranges.
Check that the location of the device is weatherproof. Do not expose it directly to rain
or liquids.
Installation, maintenance, control and eventual repairs may only be carried out by
authorized personnel. Such work must be carried out in accordance with the applica-
ble rules and regulations.