Garmin G1000 Quest Kodiak - Manual (Page 50)

Garmin G1000 Pilot’s Guide for the Quest Kodiak 100 190-00590-02 Rev. A
SYSTEM OVERVIEW
SY
STEM
O
VER
VIEW
FLIGHT
INSTRUMENTS
EIS
AUDIO P
ANEL
& CNS
FLIGHT
MANA
GEMENT
HAZARD
AV
OID
ANCE
AFCS
ADDITIONAL FEA
TURES
APPENDICES
INDEX
38
SY
STEM
O
VER
VIEW
FLIGHT
INSTRUMENTS
EIS
AUDIO P
ANEL
& CNS
FLIGHT
MANA
GEMENT
HAZARD
AV
OID
ANCE
AFCS
ADDITIONAL FEA
TURES
APPENDICES
INDEX
38 Garmin G1000 Pilot’s Guide for the Quest Kodiak 100
4) Turn the small FMS Knob to select from a list of measurement units.
5) Press the ENT Key when the desired unit is highlighted.
6) To cancel the process without changing the units, press the CLR Key.
a
rrival
a
lerts
The Arrival Alert Box on the System Setup Page allows the Alerts Window arrival alerts to be turned
ON/OFF, and the alert trigger distance (up to 99.9 units) set for alerts in the Alerts Window and the
PFD Navigation Status Box. An arrival alert can be set to notify the pilot with a message upon reaching
a user-specified distance from the final destination (the direct-to waypoint or the last waypoint in a flight
plan). When Arrival Alerts is set to ON, and the set distance is reached, an “Arrival at waypoint” message
is displayed in the PFD Navigation Status Box, and a “WPT ARRIVAL - Arriving at waypoint - [xxxx]” is
displayed in the Alerts Window. When Arrival Alerts is set to OFF, only the PFD Navigation Status Box
message “Arriving at waypoint” is displayed, and it is displayed when the time to the final destination is
approximately ten seconds.
Figure 1-34 Arrival Alert Settings (System Setup Page)
Enabling/disabling an arrival alert:
1) Use the FMS Knob to select the AUX - System Setup Page.
2) Press the FMS Knob momentarily to activate the flashing cursor.
3) Turn the large FMS Knob to select the ON/OFF field in the Arrival Alert Box.
4) Turn the small FMS Knob clockwise to turn the airspace alert ON or counterclockwise to turn the alert OFF.
Changing the arrival alert trigger distance:
1) Use the FMS Knob to select the AUX - System Setup Page.
2) Press the FMS Knob momentarily to activate the flashing cursor.
3) Turn the large FMS Knob to highlight the distance field in the Arrival Alert Box.
4) Use the FMS Knob to enter a trigger distance and press the ENT Key.