Softkey brings up the, Form. s – ACU-RITE VRO 300T User Manual
Page 46
VRO 300T
Setup
39
Calculated Entry
This brings up the softkeys needed to have the readout calculate
the compensation factors.
The
NEW
SEGMENT
softkey brings up the
CALCULATE SEGMENT
form.
S
TANDARD
—This is where you enter the actual
length of the standard.
T
RAVEL
—Shows the measured length of the
standard. This would normally be slightly
different from the actual length because of
machine inaccuracies.
F
ACTOR
—This is the compensation factor
calculated by the readout.
CALCULATE
COMP
STANDARD
0.0000
TRAVEL
0.0000
FACTOR
0000
PPM
CALCULATE SEGMENT
NEW
SEGMENT
CLEAR
TABLE
ANCHOR
SEGMENT 1
CANCEL
DONE
This manual is related to the following products: