ZyXEL Communications 802.11b/g Wireless Access Point NWA-1100 - Manual (Page 129)

ZyXEL NWA-1100 User’s Guide
129
C
H A P T E R
15
Troubleshooting
This chapter offers some suggestions to solve problems you might encounter. The potential
problems are divided into the following categories.
• Power, Hardware Connections, and LEDs
• ZyXEL Device Access and Login
• Internet Access
15.1 Power, Hardware Connections, and LEDs
V
The ZyXEL Device does not turn on. None of the LEDs turn on.
1 Make sure you are using the power adaptor or cord included with the ZyXEL Device.
2 Make sure the power adaptor or cord is connected to the ZyXEL Device and plugged in
to an appropriate power source. Make sure the power source is turned on.
3 Disconnect and re-connect the power adaptor or cord to the ZyXEL Device.
4 If the problem continues, contact the vendor.
V
One of the LEDs does not behave as expected.
1 Make sure you understand the normal behavior of the LED. See Section 1.7 on page 32 .
2 Check the hardware connections. See the Quick Start Guide.
3 Inspect your cables for damage. Contact the vendor to replace any damaged cables.
4 Disconnect and re-connect the power adaptor to the ZyXEL Device.
5 If the problem continues, contact the vendor.
15.2 ZyXEL Device Access and Login
V
I forgot the IP address for the ZyXEL Device.