ZyXEL Communications 802.11b/g Wireless Access Point NWA-1100 - Manual (Page 107)

Chapter 11 Remote Management
ZyXEL NWA-1100 User’s Guide
107
Figure 53 Remote Management: SNMP
The following table describes the labels in this screen.
Table 32 Remote Management: SNMP
LABEL DESCRIPTION
SNMP Configuration
Get Community Enter the Get Community, which is the password for the incoming Get and
GetNext requests from the management station. The default is public and
allows all requests.
Set Community Enter the Set community, which is the password for incoming Set requests
from the management station. The default is public and allows all requests.
Trap Destination Type the IP address of the station to send your SNMP traps to.
Trap Community Type the trap community, which is the password sent with each trap to the
SNMP manager. The default is “public” and allows all requests.
This field is available only when SNMPv1 or SNMPv2 is selected in the SNMP
Version field.
Configure SNMPv3
User Profile
Click this to go to the SNMPv3 User Profile screen, where you can configure
administration and user login details.
SNMP
Service Port You may change the server port number for a service if needed, however you
must use the same port number in order to use that service for remote
management.
Service Access Select the interface(s) through which a computer may access the ZyXEL Device
using this service.
Secured Client IP
Address
A secured client is a “trusted” computer that is allowed to communicate with the
ZyXEL Device using this service.
Select All to allow any computer to access the ZyXEL Device using this service.
Choose Selected to just allow the computer with the IP address that you specify
to access the ZyXEL Device using this service.