ZyXEL Communications 802.11b/g Wireless Access Point NWA-1100 - Manual (Page 117)

Chapter 13 Log Screens
ZyXEL NWA-1100 User’s Guide
117
13.5 Log Settings Screen
Use this screen to configure to where and when the ZyXEL Device is to send the logs and
which logs and/or immediate alerts it is to send.
To change your ZyXEL Device’s log settings, click LOGS > Log Settings. The screen
appears as shown.
Figure 60 Log Settings
The following table describes the labels in this screen.
Table 37 Log Settings
LABEL DESCRIPTION
Address Info
Mail Server Enter the server name or the IP address of the mail server for the e-mail
addresses specified below. If this field is left blank, logs and alert messages
will not be sent via e-mail.
Mail Subject Type a title that you want to be in the subject line of the log e-mail message
that the ZyXEL Device sends.
Send Log to Logs are sent to the e-mail address specified in this field. If this field is left
blank, logs will not be sent via e-mail.
SMTP Authentication If you use SMTP authentication, the mail receiver should be the owner of the
SMTP account.