ZyXEL Communications 802.11b/g Wireless Access Point NWA-1100 - Manual (Page 104)

Chapter 11 Remote Management
ZyXEL NWA-1100 User’s Guide
104
11.4 The Telnet Screen
Use this screen to configure your ZyXEL Device for remote Telnet access. You can use Telnet
to access the ZyXEL Device’s Command Line Interface (CLI).
Click REMOTE MGNT > TELNET. The following screen displays.
Figure 50 Remote Management: Telnet
The following table describes the labels in this screen.
11.5 The FTP Screen
Use this screen to upload and download the ZyXEL Device’s firmware using FTP. To use this
feature, your computer must have an FTP client.
To change your ZyXEL Device’s FTP settings, click REMOTE MGMT > FTP. The
following screen displays.
Table 29 Remote Management: Telnet
LABEL DESCRIPTION
TELNET
Server Port You can change the server port number for a service if needed, however you must
use the same port number in order to use that service for remote management.
Server
Access
Select the interface(s) through which a computer may access the ZyXEL Device
using Telnet.
Secured
Client IP
Address
A secured client is a “trusted” computer that is allowed to communicate with the
ZyXEL Device using this service.
Select All to allow any computer to access the ZyXEL Device using this service.
Choose Selected to just allow the computer with the IP address that you specify to
access the ZyXEL Device using this service.
Secured
Client MAC
Address
Select All to allow any computer to access the ZyXEL Device using this service.
Choose Selected to just allow the computer with the MAC address that you specify
to access the ZyXEL Device using this service.
Apply Click Apply to save your customized settings and exit this screen.
Reset Click Reset to begin configuring this screen afresh.