ZyXEL Communications NBG-417N - Manual (Page 58)

Chapter 5 AP Mode
NBG-417N User’s Guide
58
5.4.1 LAN Settings
Click Network > LAN to see the screen below.
Note: If you change the IP address of the NBG-417N in the screen below, you will
need to log into the NBG-417N again using the new IP address.
Figure 27 Network > LAN > IP
The table below describes the labels in the screen.
Table 21 Network > LAN > IP
5.4.2 WLAN and Maintenance Settings
The configuration of wireless and maintenance settings in AP Mode is the same
as for Router Mode.
• See Chapter 5 on page 69 for information on the configuring your wireless
network.
• See Maintenance and Troubleshooting (169) for information on configuring
your maintenance settings.
LABEL DESCRIPTION
Get from
DHCP Server Select this to let the DHCP server in the gateway assign the NBG-417N IP
address.
User Defined
LAN IP Select this to give the NBG-417N a static IP address.
IP Address Type the IP address in dotted decimal notatiion. The default setting is
192.168.1.2. If you change the IP address you will have to log in again
with the new IP address.
IP Subnet
Mask The subnet mask specifies the network number portion of an IP address.
Your NBG-417N will automatically calculate the subnet mask based on the
IP address that you assign. Unless you are implementing subnetting, use
the subnet mask computed by the NBG-417N.
Apply Click Apply to save your changes to the NBG-417N.
Reset Click Reset to reload the previous configuration for this screen.