ZyXEL Communications NBG-417N - Manual (Page 109)

Chapter 8 WAN
NBG-417N User’s Guide
109
8.5 Advanced WAN Screen
Use this screen to enable Multicast, allow Windows Networking and enable
Auto-bridge.
Note: The three categories shown in this screen are independent of each other.
To change your NBG-417N’s advanced WAN settings, click Network > WAN >
Advanced. The screen appears as shown.
Figure 62 Network > WAN > Advanced
Clone the
computer’s MAC
address - IP
Address Select Clone the computer's MAC address - IP Address and
enter the IP address of the computer on the LAN whose MAC you
are cloning. Once it is successfully configured, the address will be
copied to the rom file. It will not change unless you change the
setting or upload a different ROM file.
Set WAN MAC
Address Select this option and enter the MAC address you want to use.
Apply Click Apply to save your changes back to the NBG-417N.
Reset Click Reset to begin configuring this screen afresh.
Table 40 Network > WAN > Internet Connection: PPTP Encapsulation
LABEL DESCRIPTION