ZyXEL Communications 802.11g ADSL 2+ 4-Port Security Gateway HW-D Series - Manual (Page 52)

P-662H/HW-D Series User’s Guide
52 Chapter 2 Introducing the Web Configurator
2.3.1 Using the Reset Button
1 Make sure the POWER LED is on (not blinking).
2 Press the RESET button for 10 seconds or until the POWER LED begins to blink and
then release it. When the POWER LED begins to blink, the defaults have been restored
and the ZyXEL Device restarts.
You can also use the RESET button to:
• Activate/Deactivate the wireless network - by pressing the RESET button for 1 second.
• Start OTIST - by pressing the RESET button for 3 seconds.
2.4 Navigating the Web Configurator
We use the P-662HW-D1 web screens in this guide as an example. Screens vary slightly for
different ZyXEL Device models.
2.4.1 Navigation Panel
After you enter the admin password, use the sub-menus on the navigation panel to configure
ZyXEL Device features. The following table describes the sub-menus.
Figure 10 Web Configurator: Main Screen
Use
submenus
to configure
ZyXEL
Device
Click the Logout icon at any time
to exit the web configurator.
Click the Logout icon at any time
to exit the web configurator.