ZyXEL Communications Prestige 480 - Manual (Page 99)

Prestige 480 Dual BRI ISDN Router
Remote Node TCP/IP Configuration 5-3
Figure 5-3 LAN 2 Setup
5.2 Remote Node Setup
Follow the procedure in Chapter 4 - Remote Node Configuration to configure the protocol-independent
parameters in Menu 11 - Remote Node Profile. For the TCP/IP parameters, follow the instructions below. If
you are configuring your Prestige to receive incoming calls, you also need to set the default dial-in
parameters in Menu 13.
Follow the steps below to edit Menu 11.3 - Remote Node Network Layer Options shown next.
Move the cursor to the Edit IP field in Menu 11.1, then press the space bar to toggle and set the value to
Yes. Press [Enter] to open Menu 11.3 - Network Layer Options.
Figure 5-4 Menu 11.3- Remote Node TCP/IP Options
Menu 11.3 - Remote Node Network Layer Options
Rem IP Addr: 0.0.0.0
Rem Subnet Mask= 0.0.0.0
My WAN Addr= 0.0.0.0
Single User Account= No
Metric= 2
Private= No
RIP Direction= Both
Version= RIP -2B
Enter here to CONFIRM or ESC to CANCEL: