ZyXEL Communications Prestige 480 - Manual (Page 112)

Prestige 480 Dual BRI ISDN Router
IPX Configuration 6-8
6.6 IPX Remote Node Setup
Follow the procedure in Chapter 5 to configure the protocol-independent parameters in Menu 11.1 -
Remote Node Profile. For the IPX-specific parameters in Menu 11.3 - Remote Node Network Layer Options
follow the instructions below. If you want the Prestige to receive incoming calls, you must also configure the
default dial-in parameters in Menu 13.
To edit Menu 11.3 - Remote Node Network Layer Options shown next, follow these steps:
Step 1. In Menu 11.1, make sure IPX is among the protocols in the Route field. (The Route field should
display Route = IPX or Route = IP + IPX.)
Step 2. Move the cursor to the Edit IP/IPX/Bridge field, then press the space bar to select Yes and press
[Enter] to open Menu 11.3 - Network Layer Options .
Menu 11.3 - Remote Node Novell IPX Options
Menu 11.3 - Remote Node Network Layer Options
IP Options:
Rem IP Addr:
Rem Subnet Mask= N/A
My WAN Addr= N/A
Single User Account= N/A
Server IP Addr= N/A
Metric= N/A
Private= N/A
RIP Direction= N/A
Version= N/A
IPX Options:
Dial -On-Query= No
Rem LAN Net #= 00000000
My WAN Net #= 00000000
Hop Count= 1
Tick Count= 2
W/D Spoofing(min)= 3
SAP/RIP Timeout(min)= 3
Bridge Options:
Dial -On-Broadcast= N/A
Ethernet Addr Timeout(min)= N/A
Enter here to CONFIRM or ESC to CAN CEL: