ZyXEL Communications Prestige 480 - Manual (Page 115)

Prestige 480 Dual BRI ISDN Router
IPX Configuration 6-11
The following table contains the instructions on how to configure the Edit IP Static Route Menu.
Edit IPX Static Route Menu Fields
Field Description
Server Name In this field, enter the name of the server. This must be the exact name configured in
the NetWare server.
Network #
This field contains the internal network number of the remote server that you wish to
access. [00000000] or [FFFFFFFF] are reserved.
Node # This field contains the address of the node on which the server resides. If you are
using a Novell IPX implementation, this value is [000000000001].
Socket # This field contains the socket number on which the server will receive service
requests. The default for this field is hex [0451].
Type # This field identifies the type of service the server provides. The default for this field is
hex [0004].
Gateway Node In this field, enter the number of the remote node that is the gateway for this static
route.
Hop Count and
Tick Count These two fields have the same meaning as those in the Ethernet setup.
Once you have completed filling in the m enu, press [Enter] at the message [Press ENTER to Confirm…]
to save your configuration, or press [Esc] to cancel to cancel.