ZyXEL Communications Prestige 480 - Manual (Page 125)

Prestige 480 Dual BRI ISDN Router
Dial-In Server Configuration 8-3
8.2 LAN-to-LAN Server Application
Your Prestige can also be used as a dial-in server for LAN-to-LAN application to provide access for the
workstations on a remote network. For your Prestige to be set up as a LAN-to-LAN server, you need to
configure the Default Dial-In Setup to set the operational parameters for incoming calls. Additionally, you
must create a remote node for the router on the remote network (see Chapter 5 - Remote Node
Configuration).
An example of your Prestige being used as a LAN-to-LAN server is shown next.
Figure 8-2 Example of a LAN-to-LAN Server Application
Local Network Remote Network
Prestige 480 Prestige 480
ISDN
LAN-to-LAN
Server