ZyXEL Communications Prestige 480 - Manual (Page 44)

Prestige 480 Dual BRI ISDN Router
2-4 Hardware Installation and Setup
Note: You cannot access the PNC if you use the RS232 cable. You must use only the Ethernet cable.
2.4 Additional Installation Requirements
In addition to the contents of your package, there are other hardware and software requirements you need
before you can install and use your Prestige. These requirements include:
1. A computer with Ethernet 10Base-T NIC (Network Interface Card).
2. A computer equipped with communications software configured to the following parameters:
♦
VT100 terminal emulation.
♦
9600 Baud.
♦
No parity, 8 Data bits, 1 Stop bit.
2.5 Housing
Your Prestige's housing has ventilation slots for cooling and clip-out legs that fit snugly into grooves for
sturdy stacking with better airflow. ZyXEL recommends that you do not stack more than 4 routers for
maximum stack stability and cooling.
2.6 Power On Your Prestige
At this point, you should have connected the console port, the ISDN BRI port, the Ethernet port and the
power port to the appropriate devices or lines.
Step 1. Initial Screen
When you p ower on your Prestige, it performs several internal tests as well as line initialization. After the
initialization, the Prestige asks you to press [Enter] to continue, as shown.
Copyright (c) 1994 - 1999 ZyXEL Communications Corp.
initialize ch =0, ethernet address: 00:a0:c5:ff:00:35
(2) DSS1:
(2) DSS1: