ZyXEL Communications Prestige 480 - Manual (Page 60)

Prestige 480 Dual BRI ISDN Router
2-20 Hardware Installation and Setup
Figure 2-15 Menu 2.2 - NetCAPI Setup
Step 2. Set the fields in the above menu according to the following description.
Table 2-7 NetCAPI Setup Fields
Field Description
Active This field allows you to enable or disable NetCAPI. Press the [Spacebar] to toggle
between Yes and No
Max Number of
Registered Users When you want to use NetCAPI to place outgoing calls or to listen to incoming calls,
you must start RVSCOM on your workstation, and RVSCOM will register itself to the
Prestige. This option is the maximum number of clients that the Prestige supports at the
same time. The default value is 4.
Incoming Data
Call Matching This field determines how incoming calls are routed. Press the [Spacebar] to select
NetCAPI if you want to direct all incoming data calls to NetCAPI.
Select MSN if you want to direct all incoming call to the Prestige only when the
incoming phone number matches the ISDN DATA number in Menu 2. If the incoming
phone number does not match the ISDN DATA number, then the call will be routed to
NetCAPI.
Select Called Party Subaddress if you want to direct all incoming calls to the Prestige
only when the incoming call matches the subaddress of ISDN DATA in Menu 2. If the
incoming call does not match the subaddress of ISDN DATA, then the call will be routed
to NetCAPI.
Access List This list specifies users that can use NetCAPI. This access list controls if a client is
allowed to use NetCAPI. The request is rejected when
1. The IP address of the workstation is not between Start IP and End IP or
2. The request from the workstation is not permitted as specified in the
Operation field.
Start IP Refers to the first IP address of a group of NetCAPI clients. Each group contains
contiguous IP addresses.
End IP Refers to the last IP address in a NetCAPI client group.
Operation Press the [Spacebar] to select Incoming if you wish to grant incoming calls permission.
Select Outgoing if you wish to grant outgoing calls permission. Select
Both if you wish to grant both incoming calls and outgoing calls permissions. Select
None if you wish to deny all calls.