ZyXEL Communications Prestige 480 - Manual (Page 210)

Prestige 480 Dual BRI ISDN Router
14-10 Backup, Restore and Upload
If you replace the current configuration file with the default configuration file, i.e., p480.rom, you will lose
all configurations that you had before and the speed of the console port will be reset to the default of 9600
bps with 8 data bit, no parity and 1 stop bit (8n1) . You will need to change your serial communications
software to the default before you can connect to the Prestige again. The password will be reset to the default
of 1234, also.
Figure 14-10 Menu 24.7.2 - System Maintenance - Upload Router Configuration File
14.3.2 Upload using FTP
In addition to uploading the firmware and configuration via the console port and TFTP client, you can also
upload the P480 firmware and configuration files using FTP.
To use this feature, your workstation must have an FTP client. To transfer the firmware and the
configuration file, follow the examples below:
Using FTP command in terminal
Step 1. Use FTP client from your workstation to the Prestige 480 and log in by entering the IP address of
the Prestige.
Step 2. Press [ENTER] key to ignore user name.
Menu 24.7.2 - System Maintenance - Upload Router Configuration File
To upload router configuration file:
1. Enter "y" at the prompt below to go into debug mode.
2. Enter "atur3" after "Enter Debug Mode" message.
3. Wait for "Starting XMODEM upload" message before activating
Xmodem upload on your terminal.
4. After successful firmware upload, enter "atgo" to restart the
router.
Warning:
1. Proceeding with the upload will erase the current router
configuration file.
2. The router's console port speed (Menu 24.2.2) may change
when it is restarted; please adjust your terminal's speed
accordingly. The password may change (Menu 23), also.
3. When uploading the DEFAULT configuration file, the console
port speed will be reset to 9600 bps and the pa ssword to
"1234".
Do You Which To Proceed:(Y/N)