ZyXEL Communications Prestige 480 - Manual (Page 126)

Prestige 480 Dual BRI ISDN Router
8-4 Dial-In Server Configuration
8.3 Default Dial-in Setup
This section covers the default dial-in parameters. The parameters in Menu 13 affect incoming calls from
both remote dial-in users, and remote nodes until authentication is completed. Once authentication is
completed and if it matches a remote node, your Prestige will use parameters from that particular remote
node.
Figure 8-3 Menu 13 – Default Dial-in Setup
From the Main Menu, enter 13 to go to Menu 13 – Default Dial-in Setup. This section describes how to
configure the protocol-independent fields in this menu. For the protocol-dependent fields, refer to the
appropriate chapters.
The table below describes and contains information on how to configure each parameter in Menu 13 –
Default Dial-in Setup.
Table 8-2 Default Dial-in Setup Fields
Field Description Option
Menu 13 - Default Dial -in Setup
Telco Options:
CLID Authen= None
PPP Options:
Recv Authen= CHAP/PAP
Compression= Yes
Mutual Authen= No
O/G Login= 3
O/G Password= ****
Multiple Link Options:
Max Trans Rate= 256
Callback Budget Management:
Allocated Budget(min)=
Period(hr)=
IP Address Supplied By:
Dial -in User= Yes
IP Pool= No
IP Start Addr= 192.168.129.1
IP Count(1,4)= 2
Session Options:
Edit Filter Sets= No
Press ENTER to CONFIRM or ESC to CANCEL:
Press Space Bar to Toggle.