ZyXEL Communications Prestige 480 - Manual (Page 87)

Prestige 480 Dual BRI ISDN Router
Remote Node Configuration 4-1
Chapter 4
Remote Node Configuration
This chapter covers the parameters that are protocol independent. The p rotocol-
dependent configuration (TCP/IP) is covered in the next chapter.
A remote node is required for placing calls to a remote gateway. A remote node represents both the remote
gateway and the network behind it across a WAN connectio n. Note that when you use Menu 4 to set up
Internet access, you are actually configuring one of the remote nodes. Once a remote node is configured
correctly, traffic to the remote network will trigger your Prestige to make a call automatically, i.e., Dia l On
Demand.
4.1 Remote Node Setup
This section describes the protocol-independent parameters for a remote node.
4.1.1 Remote Node Profile
To configure a remote node, follow these steps:
Step 1. From the Main Menu, select menu option 11 to open Menu 11 - Remote Node Setup.
Step 2. When Menu 11 appears, as shown next, enter the number of the remote node that you wish to
configure.