Zoom HD16 - Manual (Page 153)

Reference [Projects]
ZOOM HD8/HD16 153
display.
3.
Press the [ENTER] key to erase the project.
When erasing is completed, press the [EXIT] key to return to
the main screen.
NOTE
• Once a project has been erased, it cannot be recovered. Use this
operation with care.
• A project for which protect is On cannot be erased. Set protect
to Off and then repeat the procedure.
• If you erase the project that is currently loaded, the lowest-
numbered project will automatically be loaded after the erase
operation has been completed.
This operation lets you edit the name of the currently loaded
project.
1.
Refer to steps 1 – 3 of “Basic procedure” to
bring up the indication “NAME” on the
second line of the display. Then press the
[ENTER] key.
The current project name is shown on the display.
2.
To edit the name, use the cursor left/right
keys to move the cursor (flashing part) to the
character you want to change, and turn the
dial or use the pads/keys of the pad section
to select a character.
For details on the entry procedure and available characters, see
page 37. To return to the main screen after editing the name,
press the [EXIT] key several times.
This operation lets you write-protect the currently loaded
project, which disables project storing and editing. When
protect is On, the following operations will be not be possible.
• Erasing a project
• Editing or recording on the recorder
• Changing the V-take
• Editing a patch (including module on/off)
• Recording or editing a rhythm pattern or rhythm
song
• Saving/deleting scenes, making marker settings,
etc.
• Creating a phrase loop
• Creating/editing a drum kit
1.
Refer to steps 1 – 3 of “Basic procedure” to
bring up the indication “PROTECT” on the
second line of the display. Then press the
[ENTER] key.
The screen for setting the protect status to On/Off is shown on
the display.
2.
Turn the dial to select “On” (protect enabled)
or “Off” (protect disabled).
When a project is loaded for which protect is On, a lock
symbol is shown in the top right of the display.
NOTE
• A project that is not protected will be automatically saved when
power is turned off or when another project is loaded. If you have
finished a song, we recommend to turn protect On. This will
prevent inadvertently saving changes caused by operation steps
that you have taken after finishing the song.
• A change in the protect On/Off setting becomes active
immediately. To return to the main screen after making the
setting, press the [EXIT] key several times.
Changing the project name
Protecting a project
Project Name Project Name
PRJ003 -A-
PRJ003 -A-
Project Protect Project Protect
Off
Off
Lock symbol
PRJ 0 PRJ000 PRJ 0 PRJ000
≤ У00 000:00:000
00 000:00:000