Zoom HD16 - Manual (Page 152)

Reference [Projects]
ZOOM HD8/HD16 152
This operation displays the size of the currently loaded project,
the available capacity of the internal hard disk, and the
remaining recording time.
1.
Refer to steps 1 – 3 of “Basic procedure” to
bring up the indication “SIZE” on the second
line of the display. Then press the [ENTER]
key.
2.
Use the cursor up/down keys to select the
desired screen from one the following
options.
● Remain (MB units)
This shows the remaining space on the internal hard disk in
MB (megabyte) units.
● Remain (h/m/s units)
The approximate recordable time calculated for a single
track is shown in hours (h), minutes (m), and seconds (s).
● Project Size (MB units)
This shows the size of the currently loaded project in MB
(megabyte) units.
● Project Size (h/m/s units)
This shows the size of the currently loaded project
calculated for a single track, in hours (h), minutes (m), and
seconds (s).
To return to the main screen, press the [EXIT] key several
times.
NOTE
• These screens are for display only, and contain no items that can
be edited.
• The remaining recordable time is an approximation. Use it for
general reference only.
This operation copies a specified project that is saved on the
hard disk.
1.
Refer to steps 1 – 3 of “Basic procedure” to
bring up the indication “COPY” on the
second line of the display. Then press the
[ENTER] key.
The name and number of the project to copy are shown on the
display.
2.
Turn the dial to select the copy source
project, and press the [ENTER] key.
The display changes as follows. At this screen, you can specify
the number for the copy destination project.
3.
Turn the dial to select the copy destination
project number, and press the [ENTER] key.
The indication “Copy?” appears on the second line of the
display.
4.
Press the [ENTER] key to copy the project.
When copying is completed, the unit automatically returns to
the main screen. By pressing the [EXIT] key instead of the
[ENTER] key, you can cancel the operation and back up one
step at a time.
This operation erases the specified project from the hard disk.
1.
Refer to steps 1 – 3 of “Basic procedure” to
bring up the indication “ERASE” on the
second line of the display. Then press the
[ENTER] key.
The name and number of the project to erase are shown on the
display.
2.
Turn the dial to select the project, and press
the [ENTER] key.
The indication “Erase?” appears on the second line of the
Checking the project size/
available hard disk capacity
Remain Remain
27920MB
27920MB
Duplicating a project
Erasing a project
Project Copy Project Copy
No.3:PRJ003
No.3:PRJ003
Project Copy Project Copy
Copy to No.4
Copy to No.4
Project Erase Project Erase
No.4:PRJ004
No.4:PRJ004