Zoom HD16 - Manual (Page 116)

Reference [Rhythm]
ZOOM HD8/HD16 116
4.
Use the cursor left/right keys to bring up the
indication “IMPORT” on the second line of
the display, and press the [ENTER] key.
The display indication changes as follows. In this condition,
you can select the project from which to import the kit file.
5.
Turn the dial to select the source project, and
press the [ENTER] key.
Kit files included in the selected project are listed.
6.
Turn the dial to select the kit file, and press
the [ENTER] key.
HINT
• When a file with the same name is present in the same folder on
the hard disk, a “
✽
” symbol appears on the display. This is a
warning that the file cannot be created. You must first change
the name from this screen. (For details on entering characters,
see page 37. Note that available characters are limited.)
• You can change the name of the kit file later (
→
p. 116).
7.
To execute the import process, press the
[ENTER] key once more.
You can assign a name to a kit file as follows.
1.
From the main screen, hold down the [SHIFT]
key and press pad 7 (PATTERN) or pad 8
(SONG), so that the pad lights up.
The rhythm pattern or rhythm song selection screen appears.
2.
Press the [PROJECT/UTILITY] key.
The rhythm utility menu screen appears.
3.
Verify that the indication “KIT FILE” is shown
on the second line of the display, and press
the [ENTER] key.
The display indication changes as follows.
4.
Use the cursor left/right keys to bring up the
indication “NAME” on the second line of the
display, and press the [ENTER] key.
The display indication changes as follows.
5.
Turn the dial to select the kit file whose name
you want to change, and press the [ENTER]
key.
The display indication changes as follows. In this condition,
you can change the name of the selected kit file.
HINT
When a file with the same name is present in the same folder
on the hard disk, a “
✽
” symbol appears on the display. This is
a warning that the file cannot be created.
6.
Use the cursor left/right keys to bring the
cursor to the character to change, and use
the dial and the pads/keys of the pad section
to select a character.
For details on entering characters, see page 37. (Note that
Source project name Source project number
Kit File Import Kit File Import
No.1:PRJ001
No.1:PRJ001
Kit file name
Kit File Import Kit File Import
ANALOG.ZSP
ANALOG.ZSP
Create Kit File Create Kit File
*ANALOG.ZSP
*ANALOG.ZSP
Assigning a name to a kit file
RHY UTILITY 1/9 RHY UTILITY 1/9
>KIT FILE
>KIT FILE
KIT FILE 1/6 KIT FILE 1/6
>LOAD
>LOAD
Kit File Name Kit File Name
ANALOG.ZSP
ANALOG.ZSP
Kit File Name Kit File Name
*ANALOG.ZSP
*ANALOG.ZSP