ZyXEL Communications ZyXEL ZyWALL 2WE User Manual

Page 55

Text mode
Original mode

ZyWALL 2 and ZyWALL 2WE

Introducing the SMT

4-9

4.5.2

Procedure To Use The Reset Button

Make sure the PWR LED (ZyWALL 2) or SYS LED (ZyWALL 2WE) is on (not blinking) before you begin
this procedure.

Step 1.

Press the RESET button for ten seconds, and then release it. If the SYS LED begins to blink, the
defaults have been restored and the ZyWALL restarts. Otherwise, go to step 2.

Step 2.

Turn the ZyWALL off.

Step 3.

While pressing the RESET button, turn the ZyWALL on.

Step 4.

Continue to hold the RESET button. The SYS LED will begin to blink and

flicker very quickly

after about 10 or 15 seconds. This indicates that the defaults have been restored and the ZyWALL
is now restarting.

Step 5.

Release the RESET

button and wait for the ZyWALL to finish restarting.