ZyXEL Communications ZyXEL ZyWALL 2WE User Manual
Page 415
ZyWALL 2 and ZyWALL 2WE
Log Descriptions
83
Chart Q-10 Sample IKE Key Exchange Logs
LOG MESSAGE
DESCRIPTION
!! Invalid IP
The peer’s “Local IP Addr” range is invalid.
!! Remote IP
conflicts
If the security gateway is “0.0.0.0”, the ZyWALL will
use the peer’s “Local Addr” as its “Remote Addr”. If a
peer’s “Local Addr” range conflicts with other
connections, then the ZyWALL will not accept VPN
connection requests from this peer.
!! Active connection allowed
exceeded
The ZyWALL limits the number of simultaneous Phase
2 SA negotiations. The IKE key exchange process fails
if this limit is exceeded.
!! IKE Packet Retransmit
The ZyWALL did not receive a response from the peer
and so retransmits the last packet sent.
!! Failed to send IKE Packet
The ZyWALL cannot send IKE packets due to a
network error.
!! Too many errors! Deleting SA
The ZyWALL deletes an SA when too many errors
occur.
!! Phase 1 ID type mismatch
The ID type of an incoming packet does not match the
local's peer ID type.
!! Phase 1 ID content mismatch
The ID content of an incoming packet does not match
the local's peer ID content.
!! No known phase 1 ID type
found
The ID type of an incoming packet does not match any
known ID type.
Peer ID: IP address type address> The IP address type or IP address of an incoming vs. My Remote The IP address type or IP address of an incoming
packet does not match the peer IP address type or IP
address configured on the local router. The log
displays the IP address type and IP address of the
incoming packet.
packet does not match the peer IP address type or IP
address configured on the local router. The log
displays this router’s configured remote IP address
type or IP address that the incoming packet did not
match.