ZyXEL Communications ZyXEL ZyWALL 2WE - Manual (Page 277)

ZyWALL 2 and ZyWALL 2WE
Remote Management 24-3
LAN only, Neither (Disable).
When you Choose WAN only or ALL (LAN & WAN), you still need to configure a
firewall rule to allow access.
To disable remote management of a service, select Disable in the corresponding Server Access field.
Enter 11 from menu 24 to bring up Menu 24.11 – Remote Management Control.
Figure 24-2 Menu 24.11 – Remote Management Control
Table 24-1 Menu 24.11 – Remote Management Control
FIELD DESCRIPTION EXAMPLE
Telnet Server
FTP Server
Web Server
SNMP Service
DNS Service Each of these read-only labels denotes a service that you may use to
remotely manage the ZyWALL.
Server Port This field shows the port number for the remote management service.
Except for DNS service, you may change the port number for a service
if needed, but you must use the same port number to use that service
for remote management. 23
Server Access Select the access interface (if any) by pressing [SPACE BAR], then
[ENTER] to choose from: LAN only, WAN only, ALL or Disable. LAN Only
(default)
Menu 24.11 - Remote Management Control
TELNET Server: Port = 23 Access = LAN only
Secured Client IP = 0.0.0.0
FTP Server: Port = 21 Access = LAN only
Secured Client IP = 0.0.0.0
Web Server: Port = 80 Access = LAN only
Secured Client IP = 0.0.0.0
SNMP Service: Port = 161 Access = LAN only
Secured Client IP = 0.0.0.0
DNS Service: Port = 53 Access = LAN only
Secured Client IP = 0.0.0.0
Press ENTER to Confirm or ESC to Cancel: