Texas Instruments TMS320DM357 - Manual (Page 50)

3.2.1.5 OUT Status Phase (following IN Data Phase)
USB Controller Host and Peripheral Modes Operation www.ti.com
3. When the controller generates the Endpoint 0 interrupt, read HOST_CSR0 to establish whether the
RXSTALL bit (bit 2), the ERROR bit (bit 4), the NAK_TIMEOUT bit (bit 7) or RXPKTRDY bit (bit 0) has
been set.
If RXSTALL bit is set, it indicates that the target could not complete the command and so has issued a
STALL response.
If ERROR bit is set, it means that the controller has tried to send the required IN token three times
without getting any response.
If NAK_TIMEOUT bit is set, it means that the controller has received a NAK response to each attempt
to send the IN token, for longer than the time set in the HOST_NAKLIMIT0 register. The controller can
then be directed either to continue trying this transaction (until it times out again) by clearing the
NAK_TIMEOUT bit or to abort the transaction by clearing REQPKT bit and STATUSPKT bit before
clearing the NAK_TIMEOUT bit.
4. If RxPktRdy has been set, the CPU should simply clear RxPktRdy.
For the OUT Status Phase of a control transaction ( Figure 13 ), the CPU driving the host device needs to:
1. Set STATUSPKT and TXPKTRDY bits of HOST_CSR0 (bit 6 and bit 1, respectively).
Note: These bits need to be set together.
2. Wait while the controller sends the OUT token and a zero-length DATA1 packet.
3. At the end of the attempt to send the data, the controller will generate an Endpoint 0 interrupt. The
software should then read HOST_CSR0 to establish whether the RXSTALL bit (bit 2), the ERROR bit
(bit 4) or the NAK_TIMEOUT bit (bit 7) has been set.
If RXSTALL bit is set, it indicates that the target could not complete the command and so has issued a
STALL response.
If ERROR bit is set, it means that the controller has tried to send the STATUS Packet and the following
data packet three times without getting any response.
If NAK_TIMEOUT bit is set, it means that the controller has received a NAK response to each attempt
to send the IN token, for longer than the time set in the HOST_NAKLIMIT0 register. The controller can
then be directed either to continue trying this transaction (until it times out again) by clearing the
NAK_TIMEOUT bit or to abort the transaction by flushing the FIFO before clearing the NAK_TIMEOUT
bit.
4. If none of RXSTALL, ERROR or NAK_TIMEOUT bits is set, the STATUS Phase has been correctly
ACKed.
Universal Serial Bus (USB) Controller 50 SPRUGH3 – November 2008
Submit Documentation Feedback