Connecting the printer to a single computer using – Tektronix Phaser 300X User Manual
Page 23
Getting Set Up
2
User Manual
2-9
Connecting the printer to a single computer using LocalTalk
You can use LocalTalk connectors and cables to connect the printer directly
to your computer, without connecting it to any other network.
Note
If your network consists of a single Macintosh and printer and
the cable you are using is not self-terminating, you need to
terminate both ends of the network.
1.
Turn the printer off before making any LocalTalk connections.
2.
Connect the short cable of a LocalTalk connector to the printer’s
LocalTalk port.
3.
Connect the short cable of a second LocalTalk connector to your
computer’s LocalTalk port.
4.
Connect a LocalTalk cable between the two LocalTalk connectors
you have just attached to your computer and your printer.
If you have no other connections to make, read ahead to “Turning on the
printer” on page 2-13.
8873-21
Reset
Extended
Power Up
Run
Metric
American
Variable
1
2
3
4
5
6
7
8
9
Diagnostics
Paper Size
1200
Baud Rate
Skip
Run
Startjob
*
Status
Off Off
Blue Press
Color Adjust
LocalTalk™
Serial
(RS-232)
PXi
4
3
2
LocalTalk®
Input