Tektronix Phaser 300X - Manual (Page 132)

Troubleshooting 6
User Manual 6-23
Printer standby modes
Idle for 2 hours. When the printer is idle for more than 2 hours, it goes into a
standby mode that keeps the printer ready to use and reduces energy
consumption.
The printer exits standby mode when you send a file to the printer, press one
of the front panel buttons, or open the rear cover. For example, adding ink
or changing the fuser wiper causes the printer to exit standby mode. The
printer does not purge ink when it exits standby mode after being idle for
2 hours. When the printer exits standby mode, it is ready to print in about
5 minutes.
Idle for 2 days. When the printer is idle for 2 days or more, it cools down
completely. When the printer exits the cool-down mode after being idle for
2 days, it purges ink as part of the warm-up cycle. The printer is ready to
print in about 20 minutes.