Tektronix Phaser 300X - Manual (Page 142)

Front and Rear Panels 7
User Manual 7-5
Rear panel
Rear panel switches
Note Changes to rear panel Switches 5, 6, and 7 do not take effect
until you reset the printer or turn it off and back on again.
Changes to Switches 8 and 9 take effect immediately.
Rear panel switches
Switch Function Settings
1 Reset/run Up: The printer resets and does not accept data while
the switch is in this position.
Down: The printer runs a self-test, then proceeds to run
normally. Leave the switch
down for normal operation.
2, 3, 4 Configuration
Page/
Diagnostics Up: When only Switch 4 is moved from down to up, the
printer prints a configuration page. See the table
“Switches 2, 3, and 4: Diagnostics” on page 7-6.
5 Start Job Up: The Sys/Start job on the hard disk does not run.
Down: The Sys/Start job runs if the file exists on the disk.
6 Set paper size Up: For metric-size media.
Down: For American-size media.
7 Baud Rate Up: Fixed. Sets the serial communication parameters to
1200 baud, software flagging, and ignore parity.
Down: Variable. Lets you change the serial
communication parameters. The factory setting is 9600
baud, software flagging, and ignore parity.
For information on how to change the serial port settings
when Switch 7 is in the
down position, refer to the
Phaser 300X Drivers and Utilities Printing Reference for
details on the setdevparams PostScript command.
8 and 9 Color
Correction See the table “Switches 8 and 9: Color Correction Mode”
on page 7-6.