Tektronix Phaser 300X - Manual (Page 17)

Getting Set Up 2
User Manual 2-3
Setting up the printer
Note The printer is shipped to you already loaded with ink. You do not
need to add any ink when you first set up the printer.
Removing the shipping block
1. Open the top cover.
2. Hold down the button while you open the rear cover.
3. Push the shipping block tab up and slide it, along with the
printhead, past the post.
4. Remove the shipping block, then close the covers.
1
2
4
3
8344RN1A
Note Save the shipping block to use
again if you move the printer; the
shipping block protects the
printhead.
Save all boxes and packing
material in case moving or
subsequent shipment is
necessary.
Caution You must remove all packing
material before turning the
printer on; otherwise you
will damage the printhead.