Tektronix Phaser 300X - Manual (Page 131)

6 Troubleshooting
6-22 Phaser 300X Color Printer
Delayed printout. See “Printer standby modes” on page 6-23.
Turn off the startup page. Refer to the Phaser 300X Drivers and Utilities
Printing Reference.
Leave the printer on. The printer has an automatic standby mode that keeps
the printer ready to use and reduces energy consumption. When you turn
off the printer, then turn it on again, it consumes ink; so, leaving the printer
on saves ink. However, if you will not be printing for two or more days, turn
the printer off.
After you turn on the printer, you should watch the first few messages that
appear in the front panel. You may have to add ink or empty the waste bin
before the printer continues the warm-up cycle.
The edge of the printed paper is rippled. Load paper into the printer with the
paper’s grain parallel to the paper path (the direction the paper travels while
it is fed through the printer). Refer to “All about media” on page 3-24 for
more details on paper grain.
8344-35