TRENDnet TDM-E400 - Manual (Page 80)

TDM-E400 / TDM-C400 ADSL2+ Ethernet Modem Router User’s Manual
80
2. In the interface table, select all interface names on which
you want to perform bridging and click .
To enable bridging with your ISP, select the LAN interface
(eth-0 and/or usb-0) and the EoA interface you created for the
bridging path.
After creating bridgeable interfaces, you must enable the bridging
feature, as described in the following section, “Enabling Bridging
Mode.”
To make an interface non-bridgeable, display the Bridge
Configuration page and click
next to the interface you want to
delete. Click to confirm the deletion. The interface
remains defined in the system, but is no longer capable of
performing bridging.
Enabling Bridging Mode
After you have created bridgeable interfaces, you must enable the
bridging service on the system as a whole.
1. Click the Home tab, and then click System Mode in the task
bar.
The System Mode page displays.
Figure 31. System Mode Page
You can also access the System Mode page from Bridging
page. Click any of the links that display in red near the top of
the page.
2. Click the Bridging: Enabled radio button (if not already
selected), and then click .
A page will briefly display to confirm your changes, and will
return you to the System Mode page.
3. If you want the changes to be permanent, follow the
instructions on page 46 to commit them.
The other features shown on the System Mode page are described
in “Configuring Special Bridging Features” on page on page 84.