TRENDnet TDM-E400 - Manual (Page 33)

Chapter 2. Quick Start
33
Quick Start Part 3 — Configuring the Ethernet Modem
Router
In Quick Start Part 3, you log into the program on the Ethernet
Modem Router and configure basic settings for your Internet
connection. Your ISP should provide you with the necessary
information to complete this step.
Logging in to the Ethernet Quick Configuration Page
The Ethernet Modem Router provides a preinstalled software
program called Web Configuration which enables you to configure
the operation of the device via your Web browser. The settings that
you are most likely to need to change before using the device
display on the Quick Configuration page.
Follow these instructions configure the device settings:
1. At any PC connected to the Ethernet Modem Router via
Ethernet or USB, open your Web browser, and type the
following URL in the address/location box:
192.168.1.254/MainPage?id=25
When you press , the page shown in Figure 8 should
display (see Appendix B, “Troubleshooting,” if you receive an
error message or the page does not display).
Figure 8. Quick Configuration Page in Web Configuration