TRENDnet TDM-E400 - Manual (Page 101)

Chapter 8. Configuring Dynamic Host Configuration Protocol
101
5. Click .
A page displays to confirm your changes, and the program
returns to the DHCP Relay Configuration page.
6. Follow the instructions in “Setting the DHCP Mode” to set the
DHCP mode to DHCP Relay.
Setting the DHCP Mode
You must enable the appropriate DHCP mode to activate your
DHCP relay or DHCP server settings.
Follow these instructions to set the DHCP mode:
1. Click the LAN tab, and then click DHCP Mode in the task bar.
The DHCP Configuration page displays:
Figure 39. DHCP Configuration Page
2. From the DHCP Mode drop-down list, choose DHCP Server ,
DHCP Relay , or None .
If you choose none, your LAN computers must be configured
with static IP addresses.
3. Click .
4. If you want the changes to be permanent, follow the
instructions on page 46 to commit them.