Toshiba SL-5300 Series - Manual (Page 91)

14. PROGRAMMING MODE EO1-31009
14.19 DLL (LAN Master/Satellite System) Setting
14-56
Procedure
Item Procedure
Setting to OFF Line 1. Touch the [OFF LINE] key.
2. Touch the [BACK] key.
3. Turn the power off and then on again according to the message.
Designating the scale to a
master and setting the IP
address 1. Touch the [MASTER] key.
2. Touch the [BACK] key twice.
3. Turn the power off and then on again according to the message.
NOTE: When the scale is designated to a master, its IP address will
appear as ID01 (MASTER ID) automatically. Also, all of the satellites IP
addresses are automatically displayed.
Designating the scale to a
satellite and setting the IP
address 1. Touch the [SATELLITE] key.
2. Input the IP address of the master scale.
3. Touch the IP address area (ID No. 1).
4. Touch the [BACK] key twice.
5. Turn the power off and then on again according to the message.
NOTE: When the scale is designated to a satellite, set the master
scale’s IP address only.
14.19 DLL (LAN Master/Satellite System) Setting
When the scale is designated to the master, you can download the data to the satellite using the LAN.
(Refer to Section 14.18.)
The following screen will appear when the [DLL (LAN)] key of the Programming Mode Main Menu is
touched. Select the item to be downloaded and destination satellite.
ALL key OPEN key
CLOSE key
Item key
Scale ID# key
ID02 –ID16
DLL key
DISCONNECT key
CANCEL key
ALL SATELLITES key