Toshiba SL-5300 Series - Manual (Page 200)

19. REPORT/RESET MODE EO1-31009
19.1 Label Mode Total Memory Report/Reset
19- 7
Procedure (continued)
Item Procedure
VENDOR TOTAL When using the Report No.
1. Input the Report No. (max. 4 digits) with the numeric keys, and then touch
the Report No. area.
NOTE: For the Report No., refer to the Table in Section 14.11.
2. (When specifying the code area)
Input the Start Code (max. 2 digits) and touch the START CODE area.
Then input the End Code (max. 2 digits) and touch the END CODE area.
3. To display the report on the screen, touch the [ON SCREEN] key.
To print the report on the journal paper, touch the [PRINT] key.
When selecting the total type on the screen
1. Touch the [VENDOR TOTAL] key.
2. Memory type selection
Touch the [NORMAL], [REWRAP], or [MARKDOWN] key.
3. Analysis type selection
Touch the [CODE ORDER], [CUSTOM ORDER], [ITEM ORDER], or
[AMOUNT ORDER] key.
4. Data type selection
Touch the [ALL], [ZERO SKIP], [ZERO], [BEST] or [WORST] key.
NOTE: As an example, to specify the output area “Best 10” or “Worst 10”,
enter 10 with the numeric keys and then touch the [BEST] or
[WORST] key, respectively.
5. (When specifying the code area)
Input the Start Code (max. 2 digits) and touch the START CODE area.
Then input the End Code (max. 2 digits) and touch the END CODE area.
6. To display the report on the screen, touch the [ON SCREEN] key.
To print the report on the journal paper, touch the [PRINT] key.