Daily maintenance, Cleaning, 1 cleaning – Toshiba SL-5300 Series User Manual

Page 29

11. DAILY MAINTENANCE

EO1-31009

11.1. Cleaning

11- 1

11. DAILY MAINTENANCE

Please clean the machine every day after the business hour finished so that you can always obtain
satisfactory performance of the machine. Since the print head and the platen easily get dirty, cleaning
is recommended whenever the media is replaced.

11.1 Cleaning

11.1.1 Print Head

1. Turn off the power switch.
2. Pull out the label cassette.

3. Clean the print head element (shaded part in the figure below) with a print head cleaner enclosed

with the scale.

NOTE: Please purchase the print head cleaner (P/No. 24089500013) from your authorized TOSHIBA

TEC service representative.

WARNING!

1. Do not pour water over the scale or wipe it with soaked cloth. If water enters into the machine

inside, a fire or electric shock may occur.

2. Be sure to turn off the power before cleaning. Failure to do this may cause a fire or electric shock.
3. Do not use thinner or benzine for cleaning, as this may cause a fire.
4. Do not touch the print head or around it just after printing. You may get burned as the print head

becomes very hot during printing.

CAUTION!

1. Do not use a sharp object for cleaning the print head or platen. Doing so may damage them,

causing a print failure or machine failure.

2. Do not use thinner or benzine for cleaning. Doing so may cause a print failure, machine failure, or

discoloration.

3. Do not touch the print head element, as static electricity may damage the print head.
4. Care must be taken not to give excessive pressure or shock to the platter and operation panel.

Doing so may cause a machine failure.

5. Do not scratch or damage the operation panel with a sharp or hard object. Doing so may cause a