Toshiba UNINTERRUPTIBLE POWER SYSTEM 1600XP - Manual (Page 43)

35 1600Xp Series installation and operation manual
Status Indicators
the four top and three bottom UpS status indicators on the main screen and their meanings are listed in
the table below. .
Indicator Functional Description
96% Shows the current load percentage.
100% / 11’
100% / 9’ 35”
100% / n/A
battery information: in on-line and battery back-up mode the display alternates between
battery charge percentage and estimated remaining battery runtime in:
minutes for runtimes > 10 min.
minutes and Seconds for runtimes < 10 min.
in other modes, the display alternates between battery charge percentage and “n/A.”
inV
Shows current UpS Status. indicator will change as the UpS status changes. For a
detailed listing see page 56.
12:35 pm System time
dVCoH Fault description Code - For a detailed listing see 53.
ASyn warning description Code - For a detailed listing see page 54.
on-line Current operating mode of the UpS - For a detailed listing see page 56.
Light Emitting Diodes (LED)
the following table describes the front panel led behaviors and the associated meaning.
LED Behavior Significance/Meaning
green - on UpS is in on-line, backup, or battery test mode.
green - oFF UpS in bypass mode.
green - oFF UpS in shutdown mode.
red - on one or more faults occurred. See Records: Faults for details.
red - Flashing Charger overvoltage occurred.
red - oFF no fault occurred.
Amber - on
Service Call needed, Less than 6 mo. of Battery Life or Battery Life
End.
Amber - Flashing one or more warnings occurred. See Records: Warnings for details.
Amber - oFF no warning (normal, UpS in operation).
green - on Input and Bypass voltage is within specified range.
green - Flashing Input and Bypass voltage is over specified range.
green - oFF Input and Bypass voltage is under specified range.
NOTE: On-Line/Fault LEDs - Appear Orange if Green and Red flash concurrently.
AC input
warning
on-line/
Fault