Toshiba UNINTERRUPTIBLE POWER SYSTEM 1600XP - Manual (Page 18)

10 1600Xp Series installation and operation manual
14. Warning signs should be placed on or near the load as a notification that the load is being
powered by the UpS.
15. Additional warnings and notifications shall be posted at the equipment installation location as
deemed required by Qualified Personnel.
when operating in the inverter mode, placing the
breaker in the OFF position will switch the UpS to
the battery backup mode. the output of the UpS will
continue uninterrupted to the load. the unit must be
in the bypass mode at the time that the breaker is
placed in the OFF position for the UpS to shutdown
power to the load.
Equipment Warning Labels
the following pages show examples of warning labels that may be attached to either the interior or ex-
terior of the UpS. do not remove or cover any of the labels. if the labels are damaged or if additional
labels are required, contact your equipment representative for additional labels.
these labels are placed to provide useful information or to indicate an imminently hazardous situation
that may result in severe equipment/property damage, serious injury, or loss of life if instructions are
not followed.
WARNING