2 changing the ports for oracle internet directory, 3 update targets.xml (case 2 only), Section 9.7.3, "update targets.xml (case 2 only) – Oracle B32100-01 User Manual

Page 183

Post-Installation Steps

Installing in High Availability Environments: OracleAS Cluster (Identity Management)

9-25

9.7.2 Changing the Ports for Oracle Internet Directory

Although it is recommended that the ports for the LDAP virtual server and the Oracle
Internet Directory are the same, it is possible for the ports to be different.

See the section "Changing Oracle Internet Directory Ports" in the Oracle Application
Server Administrator’s Guide for details on changing the Oracle Internet Directory ports.

9.7.3 Update targets.xml (Case 2 only)

The following configuration steps are needed only in the installation scenario
described in

Section 9.4.2, "Case 2: Client ---[HTTPS]---> Load Balancer ---[HTTPS]--->

Oracle HTTP Server"

In this case the oracle_sso_server entry in the targets.xml file, on each physical host
of the cluster, must be reconfigured to monitor the local SSL port.

Perform the following steps to update targets.xml on each node of the cluster:

Back up the targets.xml file:

cp ORACLE_HOME/sysman/emd/targets.xml

ORACLE_HOME/sysman/emd/targets.xml.BACKUP

Open the file and find the oracle_sso_server target type. Within this target entry,
locate and edit the following two attributes:

■

HTTPPort - the server SSL port number

■

HTTPProtocol - the server protocol, which in this case is HTTPS

For example, you could update the two attributes this way:

Save and close the file.

Reload the OracleAS console:

ORACLE_HOME/bin/emctl reload

Note:

When choosing a multicast address, ensure that the address

does not collide with the addresses listed in:

http://www.iana.org/assignments/multicast-addresses

Also, if the low order 23 bits of an address is the same as the local
network control block, 224.0.0.0 – 224.0.0.255, then a collision may
occur. To avoid this problem, provide an address that does not have
the same bits in the lower 23 bits of the address as the addresses in
this range.

Note:

Keep in mind that the hostname should remain the same. Please do
not change the hostname.