Roland VC-2 - Manual (Page 61)

61
Effects List
The functions of Chorus parameters are explained.
Chorus Type
01: Chorus 1
This conventional chorus effect adds spaciousness and depth
to the sound. Slow modulation frequency with less depth.
02:Chorus 2
This conventional chorus effect adds spaciousness and depth
to the sound. Rapid modulation frequency with less depth.
03: Chorus 3
This conventional chorus effect adds spaciousness and depth
to the sound. Slow modulation frequency with more depth.
04: Chorus 4
This conventional chorus effect adds spaciousness and depth
to the sound. Rapid modulation frequency with more depth.
05: Feedback Chorus
This chorus offers a flanger-like effect, creating a soft sound.
06: Flanger
This effect sounds somewhat like a jet airplane taking off and
landing.
07: Short Delay
This is a delay with a short delay time.
08: Fbk Short Delay
This is a short delay with many repeats.
Chorus Parameters
Chorus Parameters
Parameter Value Description
Pre Low Freq 500–15000 Hz,
THRU Frequency of the low range (TH-
RU: no filter is used)
Pre Hi Freq THRU, 50–800
Hz Frequency of the high range (TH-
RU: no filter is used)
Pre Dly Time 0–50.0 ms Adjusts the delay time from the
direct sound until the chorus
sound is heard.
Co LPF Freq 500–15000 Hz,
THRU Adjusts the cutoff frequency of
the low pass filter. (THRU: no fil-
ter is used)
The effect will be applied to the
frequency range below the cutoff
frequency.
Co HPF Freq THRU, 50–800
Hz Adjusts the cutoff frequency of
the high pass filter. (THRU: no
filter is used)
The effect will be applied to the
frequency range above the cutoff
frequency.
Rate 0.05–10.0 Hz,
note Sets the cycle for the chorus or
flanger sound undulations.
Depth 0–127 Adjusts the depth of modulation
for the chorus or flanger.
Feedback -98– +98 % Adjusts the proportion of the ef-
fect sound that is fed back into
the effect. Negative (-) settings
will invert the phase.
Cho/Flg Sw CHORUS,
FLANGER Selects either chorus or flanger.
vc2_for_XT_e1 61 ページ ２００５年３月８日 火曜日 午後４時５２分